Zhen Yin

Creep-feed grinding of different nickel-based superalloys: grinding temperature, and its effect on material removal behavior, tool surface state and surface integrity

Yang Xu, Qing Miao, Wenfeng Ding, Zhen Yin et autres

cn (code pays fourni par la source)

Milling of disc cutter replacing traditional grinding mechanism in machining of nickel-based superalloy honeycomb composites under ice-freezing condition

Haihang Wang, Chenguang Wang, Pengjie Gao, H S Li et autres

The nickel-based superalloy honeycomb composite (NBSHC) is widely applied in aerospace and defense due to its low density, high-temperature resistance, and excellent specific strength. Although grinding is the conventional method for machining NBSHC, its efficiency and quality are limited. Therefore, disc-cutter milling …

cn (code pays fourni par la source)

Surface damage characterisation of longitudinal torsional ultrasonic vibration-assisted grinding of orthogonally woven SiCf/SiC composites based on different fibre orientation

Qixuan Sun, Zhen Yin, Qinglong An, Zehui Liang et autres

cn, ua (code pays fourni par la source)

Simulation and experimental studies on the hydrodynamic behavior and induced erosion characteristics of ultrasonic cavitation

Chenwei Dai, Xingwang Chen, Qing Miao, Zhen Yin et autres

cn (code pays fourni par la source)

Research on removal mechanism of longitudinal-torsional compound ultrasonic vibration end grinding sapphire

Zhen Yin, Hailong Xu, Qing Miao, Zhiqiang Liang et autres

cn (code pays fourni par la source)

Synergistic mechanism of bubble evolution and material removal during the rough trimming in wire EDM-ECM regulated by interpulse voltage

Ming Zhang, Qiuying Zhao, Yao Yao, Zhen Yin et autres

cn (code pays fourni par la source)

Investigation on ultrasonic vibration assisted drilling of monocrystalline silicon: exit-chipping formation mechanism and axial force analysis

Mengqiu Yu, Zhen Yin, Qinglong An, Dingyi Tao et autres

cn (code pays fourni par la source)

Research on cutting forces and tool wear during tilted ultrasonic elliptical vibration cutting of Ti-6Al-4V

Zhen Yin, Jingcai Cheng, Qing Miao, Chenwei Dai et autres

cn (code pays fourni par la source)

Prediction and suppression of exit burr height in ultrasonic vibration-assisted micro-drilling of GH4169 superalloy

Dingyi Tao, Zhen Yin, Qinglong An, Mengqiu Yu et autres

cn (code pays fourni par la source)

Influence of bubble distribution produced by no-load pulse on straightness error in WEDM trimming

Ming Zhang, Cong Deng, Yao Yao, Zhen Yin

cn (code pays fourni par la source)

Research on burr height prediction and inhibition strategy of high-temperature alloy ultrasonic vibration micro drilling outlet

Dingyi Tao, Zhen Yin, Qinglong An, Mengqiu Yu et autres

cn (code pays fourni par la source)

Debris motion and taper suppression in EDM deep hole machining assisted by longitudinal/torsional ultrasonic vibration

Pengxiang Wang, Jie Hu, Hao Hu, Daguo Yu et autres

Ti-6Al-4 V is usually machined using EDM methods due to its hard-to-cut characteristics. However, the challenge of chip removal in micro-deep hole machining causes ablation product buildup, leading to electrode wear and tapered holes. An Ultrasonic-assisted spark discharge energy model was developed …

cn (code pays fourni par la source)