Accès ouvert
2026
article
OpenAlex
Ryuta Ichiki, Takashi Furuki, Seiji Kanazawa
Surface layers of expanded austenite (S-phase) are formed on JIS SUS304 austenitic stainless steel by nitrogen doping using a pulsed-arc plasma jet under atmospheric pressure. The characteristics of the formed S-phase strongly depend on the fraction of hydrogen gas in the operating …
jp
(code pays fourni par la source)
2024
article
OpenAlex
Shoho Ando, Koki Koyanagi, Ryuta Ichiki, Takefumi Otsu et autres
We performed the ball-on-disk tribological test for tool steels nitrided by the atmospheric-pressure pulsed-arc plasma jet to investigate improvement of the wear resistance. The test with an alumina ball proved that the plasma-jet nitriding decreases the wear rate approximately by half. Moreover, …
jp
(code pays fourni par la source)
2023
conference-paper
OpenAlex
Seiji Kanazawa, T. Mitsui, Akihito Kuno, Takashi Furuki et autres
jp, pl
(code pays fourni par la source)
Accès ouvert
2022
report
OpenAlex
Yuko Iwami, Hirofumi Kumasako, Takashi Furuki, Toshitaka Matsuki et autres
Accès ouvert
2022
report
OpenAlex
Iori Miura, Shohei Ueno, Toshitaka Matsuki, Takashi Furuki et autres
Accès ouvert
2022
article
OpenAlex
Kosuke Tachibana, Ryosuke Hanabata, Takashi Furuki, Ryuta Ichiki et autres
Water purification by non-equilibrium atmospheric pressure plasma has attracted much attention and is expected to be a next-generation method. However, general approaches to improve the energy efficiency of the water purification have not been revealed. Therefore, to investigate important factors for increasing …
jp, pl
(code pays fourni par la source)
2022
article
OpenAlex
Seiji Kanazawa, J. Mizeraczyk, Toshiaki Nakatani, Akihito Kuno et autres
jp, pl
(code pays fourni par la source)
Accès ouvert
2022
preprint
OpenAlex
Seiji Kanazawa, J. Mizeraczyk, Toshiaki Nakatani, Akihito Kuno et autres
jp
(code pays fourni par la source)
Accès ouvert
2022
article
OpenAlex
Ryuta Ichiki, N. Yagawa, Takashi Furuki, Seiji Kanazawa
A unique nitriding technique using the atmospheric-pressure plasma jet has been upgraded by extending the treatable area. The previous manner to heat up a steel sample was spraying the thermal plasma jet onto the sample surface, which could maintain the treatment temperature …
jp
(code pays fourni par la source)
Accès ouvert
2021
article
OpenAlex
Ryuta Ichiki, Tomoki Komatsu, Kaito Yakushiji, Kosuke Tachibana et autres
We discovered that the ignition area of a planar dielectric barrier discharge gradually extends beyond the area of the opposite electrode when the ambient temperature increases. Even with the opposite electrode the sectional area of which is less than 1 mm 2 …
jp
(code pays fourni par la source)
2020
article
OpenAlex
Kosuke Tachibana, Takahiro Koshiishi, Takashi Furuki, Ryuta Ichiki et autres
jp, pl
(code pays fourni par la source)
Accès ouvert
2020
article
OpenAlex
Kiho Toda, Ryuta Ichiki, Yuka Kanbara, Kento Kojima et autres
Abstract Bright nitriding of a steel surface is demonstrated by an atmospheric-pressure pulsed-arc plasma jet, keeping the original metallic luster and low roughness. As the hydrogen fraction in the nitrogen–hydrogen gas mixture increases, the optical emission intensity of NH radicals decreases. Following …
jp
(code pays fourni par la source)