Influence of the Spent Coffee Ground-to-Ammonium Lignosulfonate Ratio on the Performance of Wood-Fiber Biocomposites
Rattachement africain : bg, gr, my. Niveau de preuve : code pays fourni par la source.
Le résumé fourni par la source
Spent coffee grounds (SCGs) and ammonium lignosulfonate (ALS) are promising renewable constituents for wood-fiber biocomposites, but the effect of their relative proportion within the binder phase remains insufficiently understood. This preliminary study evaluated wood-fiber panels produced at a constant dry-matter matrix-to-fiber ratio of 50:50 while varying the SCG:ALS ratio from 70:30 to 30:70. The panels were hot-pressed and characterized for their physical and mechanical properties, while the corresponding SCG–ALS matrix formulations were evaluated by simultaneous TGA–DSC analysis. Increasing the SCG fraction generally improved dimensional stability and mechanical performance, whereas formulations containing 50% or more ALS showed a marked deterioration in water resistance. The SCG-rich 70:30 formulation provided the highest bending performance, with MOE and MOR values of 2156.5 and 12.83 N·mm−2, respectively. Thermal analysis revealed ratio-dependent changes in mass loss and in the principal heat-flow event, which occurred between approximately 113 and 136 °C, confirming that the SCG:ALS ratio altered the early thermal behavior of the binder system. Overall, the SCG:ALS ratio was identified as a key formulation parameter, with SCG-rich systems providing the most favorable balance between mechanical performance, dimensional stability, and internal cohesion.
Ce résumé expose les affirmations des auteurs. BNTIC ne l’interprète pas comme une validation indépendante des résultats.
Le contrôle bibliographique ouvert
DOI retrouvé dans Crossref DOI retrouvé ; titre concordant.
- Titre Crossref
- Influence of the Spent Coffee Ground-to-Ammonium Lignosulfonate Ratio on the Performance of Wood-Fiber Biocomposites
- Date Crossref
- 03/09/2026
- Éditeur
- MDPI AG
- Type
- journal-article
Ce recoupement confirme des métadonnées liées au DOI. Il ne confirme ni la méthode ni les conclusions de l’étude, et il ne compte pas comme une seconde source scientifique indépendante.
Où se fait cette recherche
-
University of Forestry pays non établi dans la noticeUniversité ou école supérieure
-
University of Thessaly pays non établi dans la noticeUniversité ou école supérieure
-
Development Agency of Karditsa pays non établi dans la noticeInstitution
-
University of Chemical Technology and Metallurgy pays non établi dans la noticeUniversité ou école supérieure
-
Universiti Malaysia Pahang Al-Sultan Abdullah pays non établi dans la noticeUniversité ou école supérieure
-
Universiti Teknologi MARA pays non établi dans la noticeUniversité ou école supérieure
-
Center of Competence “Clean Technologies for a Sustainable Environment—Water pays non établi dans la noticeInstitution
-
Faculty of Forest Industry pays non établi dans la noticeUniversité ou école supérieure
-
Faculty of Ecology and Landscape Architecture pays non établi dans la noticeUniversité ou école supérieure
-
School of Technology Department of Forestry pays non établi dans la noticeUniversité ou école supérieure
-
Faculty of Chemical Technologies pays non établi dans la noticeUniversité ou école supérieure
-
Faculty of Applied Sciences Department of Wood Industry pays non établi dans la noticeUniversité ou école supérieure
University of Forestry, University of Thessaly et Development Agency of Karditsa, avec 9 autres affiliations.
Une affiliation ne permet pas de déduire la nationalité d’un auteur.