Assessment of Thermal Management Using a Phase-Change Material Heat Sink under Cyclic Thermal Loads

Le résumé fourni par la source

Phase-change materials (PCMs) are widely used in the thermal management of electronic devices by effectively lowering the hot end temperature and increasing the energy conversion efficiency. In this article, numerical studies were performed to understand how temperature instability during the periodic utilization of electronic devices affects the heat-dissipation effectiveness of a phase-change material heat sink embedded in an electronic device. Firstly, three amplitudes of 10 °C, 15 °C, and 20 °C for fixed periods of time, namely, 10 min, 20 min, and 40 min, respectively, were performed to investigate the specific effect of amplitude on the PCM melting rate. Next, the amplitude was fixed, and the impact of the period on heat sink performance was evaluated. The results indicate that under the 40 min time period, the averaged melting rate of PCMs with amplitudes of 20 °C, 15 °C, and 10 °C reaches the highest at 19 min, which saves 14 min, 10 min, and 8 min, respectively, compared with the constant input of the same melting rate. At a fixed amplitude of 20 °C, the PCM with a period of 40 min, 20 min, and 10 min has the highest averaged melting rate at 6 min, 11 min, and 19 min, saving the heat dissipation time of 3 min, 8 min, and 14 min, respectively. Overall, it was observed that under identical amplitude conditions, the peak melting rate remains consistent, with longer periods resulting in a longer promotion of melting. On the other hand, under similar conditions, larger amplitude values result in faster melting rates. This is attributed to the fact that the period increases the heat flux output by extending the temperature rise, while the amplitude affects the heat flux by adjusting the temperature.

Ce résumé expose les affirmations des auteurs. BNTIC ne l’interprète pas comme une validation indépendante des résultats.