Fabrication of NBI Ion Source Back Plate and its High Heat Flux Experiment

Résumé fourni par la source

The back plate is an important component of the ion source because of its multiple roles including heat load removal during beam operation. The main components of the back plate are (1) a Type 304L stainless steel (SS304L) magnet positioning plate that holds samarium cobalt permanent magnets required for the confinement of ion source plasma, (2) an oxygen-free electronic copper cooling plate with 35 inner and 8 outer cooling channel grooves (each of which is 4 × 1.8 mm2) that is vacuum brazed with a SS304L magnet positioning plate, and (3) a SS304L magnet cover plate. In this paper, the back plate is successfully fabricated, and a high heat flux experiment is done at the High Heat Flux Test Facility Center with an electron beam power of 200 kW for 458 s. The uniform incident heat flux is 2.5 MW/m2. Demineralized water at 34°C is supplied at the rate of 1 kg/s to the cooling plate at inlet pressure of 8.2 bars to remove the high heat load. The surface temperature of the copper plate is measured by an infrared camera, and three temperature regions are observed. The measured average surface temperature of the cooling plate is ~152°C. The bulk water temperature rise ΔTw is ~39.42°C. The estimated absorbed heat flux is ~2.04 MW/m2, and the heat absorption coefficient is 81.6%. The measured leak rate after the heat flux test is 1.6 × 10−8 mbars∙L/s. These High Heat Flux Test experimental results will be useful to study the thermomechanical performance of the back plate and to understand the effect of increasing the beam pulse length.

Ce résumé expose les affirmations des auteurs. BNTIC ne l’interprète pas comme une validation indépendante des résultats.