Dual high-order QAM-modulated mm-wave signal transmission in the Q-band enabled by simple IM/DD architecture and bandpass delta-sigma modulation

Le résumé fourni par la source

The intensity-modulation (IM)/direct-detection (DD) systems have been proven effective and low-cost due to their simple system architecture. However, the Mach–Zehnder modulator (MZM) of the IM/DD systems only reserves its driving signal intensity. Therefore, the IM/DD systems are generally unable to transmit vector signals and have a restricted spectrum efficiency and channel capacity. Similarly, the radio-over-fiber (RoF) transmission systems based on IM/DD are limited by their simple architecture and generally cannot transmit high-order quadrature amplitude modulation (QAM) signals, which hinders the improvement of their spectrum efficiency. To address the challenges, we propose a novel, to the best of our knowledge, scheme to simultaneously transmit the dual independent high-order QAM-modulated millimeter-wave (mm-wave) signals in the RoF system with a simple IM/DD architecture, enabled by precoding-based optical carrier suppression (OCS) modulation and bandpass delta-sigma modulation (BP-DSM). The dual independent signals can carry different information, which increases channel capacity and improves spectrum efficiency and system flexibility. Based on our proposed scheme, we experimentally demonstrate the dual 512-QAM mm-wave signal transmission in the Q-band (33–50 GHz) under three different scenarios: 1) dual single-carrier (SC) signal transmission, 2) dual orthogonal-frequency-division-multiplexing (OFDM) signal transmission, and 3) hybrid SC and OFDM signal transmission. We achieve high-fidelity transmission of dual 512-QAM vector signals over a 5 km single-mode fiber (SMF) and a 1-m single-input single-output (SISO) wireless link operating in the Q-band, with the bit error rates (BERs) of all three scenarios below the hard decision forward error correction (HD-FEC) threshold of 3.8 × 10 −3 . To the best of our knowledge, this is the first time dual high-order QAM-modulated mm-wave signal transmission has been achieved in a RoF system with a simple IM/DD architecture.

Ce résumé expose les affirmations des auteurs. BNTIC ne l’interprète pas comme une validation indépendante des résultats.