Influence of Vanadium Micro-Alloying on the Microstructure of Structural High Strength Steels Welded Joints
Rattachement africain : it. Niveau de preuve : code pays fourni par la source.
Le résumé fourni par la source
The inter-critically reheated grain coarsened heat affected zone (IC GC HAZ) has been reported as one of the most brittle section of high-strength low-alloy (HSLA) steels welds. The presence of micro-alloying elements in HSLA steels induces the formation of microstructural constituents, capable to improve the mechanical performance of welded joints. Following double welding thermal cycle, with second peak temperature in the range between Ac1 and Ac3, the IC GC HAZ undergoes a strong loss of toughness and fatigue resistance, mainly caused by the formation of residual austenite (RA). The present study aims to investigate the behavior of IC GC HAZ of a S355 steel grade, with the addition of different vanadium contents. The influence of vanadium micro-alloying on the microstructural variation, RA fraction formation and precipitation state of samples subjected to thermal cycles experienced during double-pass welding was reported. Double-pass welding thermal cycles were reproduced by heat treatment using a dilatometer at five different maximum temperatures of the secondary peak in the inter-critical area, from 720 °C to 790 °C. Although after the heat treatment it appears that the addition of V favors the formation of residual austenite, the amount of residual austenite formed is not significant for inducing detrimental effects (from the EBSD analysis the values are always less than 0.6%). Moreover, the precipitation state for the variant with 0.1 wt.% of V (high content) showed the presence of vanadium rich precipitates with size smaller than 60 nm of which, more than 50% are smaller than 15 nm.
Ce résumé expose les affirmations des auteurs. BNTIC ne l’interprète pas comme une validation indépendante des résultats.
Le contrôle bibliographique ouvert
DOI retrouvé dans Crossref DOI retrouvé ; titre concordant.
- Titre Crossref
- Influence of Vanadium Micro-Alloying on the Microstructure of Structural High Strength Steels Welded Joints
- Date Crossref
- 05/04/2023
- Éditeur
- MDPI AG
- Type
- journal-article
Ce recoupement confirme des métadonnées liées au DOI. Il ne confirme ni la méthode ni les conclusions de l’étude, et il ne compte pas comme une seconde source scientifique indépendante.
Où se fait cette recherche
-
University of Perugia pays non établi dans la noticeUniversité ou école supérieure
-
National Agency for New Technologies pays non établi dans la noticeOrganisme public
-
Istituto Italiano della Saldatura pays non établi dans la noticeOrganisation à but non lucratif
-
Alenia Aermacchi pays non établi dans la noticeEntreprise
-
Space (Italy) pays non établi dans la noticeEntreprise
-
Dipartimento di Ingegneria pays non établi dans la noticeInstitution
-
Vantage Alloys AG pays non établi dans la noticeInstitution
-
Dipartimento Sostenibilità dei Sistemi Produttivi e Territoriali pays non établi dans la noticeInstitution
-
Lungobisagno Istria 15 Istituto Italiano della Saldatura pays non établi dans la noticeOrganisation à but non lucratif
-
Aeronautical and Space Test Division pays non établi dans la noticeInstitution
-
CALEF-ENEA CR Casaccia pays non établi dans la noticeInstitution
University of Perugia, National Agency for New Technologies et Istituto Italiano della Saldatura, avec 8 autres affiliations.
Une affiliation ne permet pas de déduire la nationalité d’un auteur.