Understanding baffle overloads observed in high-mirror configuration on Wendelstein 7-X
Rattachement africain : de, pl, cz, it, jp. Niveau de preuve : code pays fourni par la source.
Le résumé fourni par la source
The operational regimes in the first divertor campaign of W7-X were limited by unexpectedly high heat loads on certain baffle tiles. In the high-mirror configuration, a permanent hotspot on the baffle plate was detected by the thermographic system, which was further confirmed during the post-campaign inspections of the plasma-facing components. The maximum heat load on three baffle tiles reached about 4.5 MW m −2 , which was almost an order of magnitude above its designed value of 0.5 MW m −2 . The paper presents a detailed analysis to understand how the baffle plate, which is originally designed to screen the recycling neutrals and is therefore hidden from the hot plasma, can receive such a high heat load - a level that is expected for target plates. Three main causes have been identified: 1) the three baffle tiles are radially only about 5 mm away from a main heat channel towards a target, which is much shorter than the radial power decay length of several centimeters derived from the thermographic measurements in this region; 2) the three baffle tiles are intersected with field-lines of about 30 m length, which are long enough to collect considerable amount of heat via cross-field transport; 3) the baffle tiles have locally large grazing angles. In addition, the analysis method shown in this paper is of general use to estimate the heat flows in shadow areas of targets and thus to evaluate heat loads on the potentially critical components occurring in these areas, especially required for the design of complex 3D divertors like the one in W7-X.
Ce résumé expose les affirmations des auteurs. BNTIC ne l’interprète pas comme une validation indépendante des résultats.
Le contrôle bibliographique ouvert
DOI retrouvé dans Crossref DOI retrouvé ; titre concordant.
- Titre Crossref
- Understanding baffle overloads observed in high-mirror configuration on Wendelstein 7-X
- Date Crossref
- 04/08/2020
- Éditeur
- IOP Publishing
- Type
- journal-article
Ce recoupement confirme des métadonnées liées au DOI. Il ne confirme ni la méthode ni les conclusions de l’étude, et il ne compte pas comme une seconde source scientifique indépendante.
Où se fait cette recherche
-
Max Planck Society pays non établi dans la noticeOrganisation à but non lucratif
-
Max Planck Institute for Plasma Physics - Greifswald Stellarator Edge and Divertor Physics (E4) pays non établi dans la noticeStructure de recherche
-
Max Planck Institute for Plasma Physics pays non établi dans la noticeStructure de recherche
-
University of Szczecin pays non établi dans la noticeUniversité ou école supérieure
-
Institute of Physics pays non établi dans la noticeStructure de recherche
-
Czech Academy of Sciences pays non établi dans la noticeStructure de recherche
-
University of Cagliari Department of Electrical and Electronic Engineering (DIEE) pays non établi dans la noticeUniversité ou école supérieure
-
National Institutes of Natural Sciences pays non établi dans la noticeStructure de recherche
-
The Graduate University for Advanced Studies pays non établi dans la noticeUniversité ou école supérieure
-
National Institute for Fusion Science pays non établi dans la noticeStructure de recherche
-
Max-Planck-Institut für Plasmaphysik Edge and Divertor Physics pays non établi dans la noticeStructure de recherche
-
Max-Planck-Institut fuer Plasmaphysik Wendelsteinstrasse 1 pays non établi dans la noticeStructure de recherche
Max Planck Society, Stellarator Edge and Divertor Physics (E4) — Max Planck Institute for Plasma Physics - Greifswald et Max Planck Institute for Plasma Physics, avec 9 autres affiliations.
Une affiliation ne permet pas de déduire la nationalité d’un auteur.