Aller au contenu principal
Accès ouvert déclaré 2016 article

Performance Analysis of Mass-Produced Nb3Sn Conductor for Central Solenoid in ITER

6Citations signalées, ce qui n’est pas une note de qualité
5Institutions déclarées
2Pays d’affiliation déclarés

Rattachement africain : jp, ch. Niveau de preuve : code pays fourni par la source.

Le résumé fourni par la source

The performance of two mass-produced Nb3Sn conductors for the ITER central solenoids was tested for the first timmass-produced Nb3Sn conductorse. One was cut from the forward end of an 80-m-long conductor, and the other was cut from the forward end of a 918-m-long conductor. The fifth-stage twist pitches of these conductors were lengthened by approximately 16% during cable insertion and compaction with conduit. The current sharing temperatures Tcs were measured over 20 000 electromagnetic cycles, including four thermal cycles between 4.2 K and room temperature. The Tcsof the former conductor increased and became almost constant through the cycling. In contrast, Tcsof the latter conductor not only increased but also decreased slightly against cycling. The Tcsdecline rate after 10002 cycles was -4.50 × 10-6 K/cycle. If this rate is assumed to continue after 20000 cycles, Tcs would decrease by -0.27 K over 60000 cycles. Even so, Tcsis higher than an acceptance criterion of 6.5 K at 60 000 cycles. The ac losses Q of both conductors at a current of 0 kA were almost the same as or slightly lower than Q of a short sample conductor whose fifth-stage twist pitch was not lengthen. On each conductor, Q at 40 kA was approximately 10% higher than that at 0 kA; thus, the effect of the transport current on Q was not large.

Ce résumé expose les affirmations des auteurs. BNTIC ne l’interprète pas comme une validation indépendante des résultats.

Le contrôle bibliographique ouvert

DOI retrouvé dans Crossref DOI retrouvé, mais le titre doit être comparé manuellement.

Titre Crossref
Performance Analysis of Mass-Produced Nb<sub>3</sub>Sn Conductor for Central Solenoid in ITER
Date Crossref
01/06/2016
Éditeur
Institute of Electrical and Electronics Engineers (IEEE)
Type
journal-article

Ce recoupement confirme des métadonnées liées au DOI. Il ne confirme ni la méthode ni les conclusions de l’étude, et il ne compte pas comme une seconde source scientifique indépendante.

Où se fait cette recherche

  • Japan Atomic Energy Agency pays non établi dans la notice
    Organisme public
  • International Superconductivity Technology Center pays non établi dans la notice
    Structure de recherche
  • Mitsubishi Group (Japan) pays non établi dans la notice
    Entreprise
  • Ltd. (Japan) Mitsubishi Cable Industries pays non établi dans la notice
    Entreprise
  • École Polytechnique Fédérale de Lausanne pays non établi dans la notice
    Université ou école supérieure
  • Inc. Japan Supercond. Technol. pays non établi dans la notice
    Entreprise
  • Mitsubishi Cable Ind. Ltd. pays non établi dans la notice
    Entreprise
  • Mitsubishi Cable Industries Ltd. pays non établi dans la notice
    Entreprise
  • Centre de Rech. en Phys. des Plasmas pays non établi dans la notice
    Institution

Japan Atomic Energy Agency, International Superconductivity Technology Center et Mitsubishi Group (Japan), avec 6 autres affiliations.

Une affiliation ne permet pas de déduire la nationalité d’un auteur.

Les sujets associés

Superconducting Materials and ApplicationsParticle accelerators and beam dynamicsPhysics of Superconductivity and Magnetism

BNTIC News n’est pas le producteur de ces données. Les publications sont interrogées à la demande dans Crossref, OpenAIRE, DOAJ, Europe PMC, HAL, DataCite, AfricArXiv, ROR et la Banque mondiale, sans clé d’accès. OpenAlex reste optionnel. Aucun service payant n’est nécessaire et aucune donnée externe n’est enregistrée en base. Consulter les sources et leurs limites.